Hall Research UHBX-SW3-WP - Manual (Page 19)

17
© Copyright 2015. Hall Research, Inc.
All rights reserved.
UHBX-SW3-WP

Status Update :
Command: SU <cr> Stands for get full Status Update
Response: PWn <cr> APn <cr> ISn <cr> AIn <cr> ODn <cr> SPn,m <cr> ARn
<cr> BNn <cr> CLn <cr> CTn <cr> ICn <cr> LRn <cr> OSn <cr>
TBn <cr> USn <cr> FWx.x <cr>
 Factory Default:
Command: FD <cr> Stands for Factory Default
Response: FD <cr>

Firmware Version :
Command: FW <cr> Stands for Firmware Version
Response: FWx.x <cr> UHBX-SW3-WP Firmware Version

Button :
Command: BLn,m <cr> Stands for Aux keypad Button LED
Response: BLn,m <cr> Where n = 1 - 3 = PWR LED – MUTE LED
m = 0 - 1 = LED Off – LED On

Volume Up :
Response: UP <cr> Stands for Volume Up
Sent when user pushes the Volume Up button on Aux Kpd

Volume Down :
Response: DN <cr> Stands for Volume Down
Sent when user pushes the Volume Down button on Aux Kpd
Error Commands
ERR0 – UHBX-SW3-WP power is off.
ERR1 – Invalid command
ERR2 – The VGA scaler board is in low power mode
Notice If n is not specified in any of the commands above, the
command becomes a query command instead of a set
command.
In response to a query command the system reports the
current status of that command.