Hanna Instruments HI 98280 - Manual (Page 44)

44
• Then the “Add remark?” window will appear. If <Yes> is pressed and a remark
list already exists, the user can select the desired note or press <New> to
insert a new remark in the displayed text box.
• If the GPS is enabled, the meter will ask if a
location should be associated with the read-
ings. Press <Yes> to add the location (new or
from the nearby existing list); press <No> to
skip this option.
• If the continuous logging mode was selected
and the GPS is enabled, the message “Do you
want to switch OFF the GPS unit after the first
sample to save power?” will appear.
In case of continuous logging in the same
place, it is recommended to confirm by press-
ing <Yes>.
The “N” (North, or “S” South) and “E” (East, o “W” West) indications near the
GPS coordinates will be shown alternately with the “H” (Hold) tag.
When the logging is stopped, the GPS unit will automatically switch on again.
• The “Tag reading” option allows to associate the
sample to a tag. The message “Touch the tag
with the tag reader” is displayed. Press <Skip>
if no tag is available or to skip this option.
• If the tag is touched, the associated ID will be
displayed. If no ID is associated to the tag, the
serial number is shown.
• Press <Tag ID> to insert an identification code for the used tag, then press
<OK> (or simply press <OK> if you are not interested in a tag ID).