Hanna Instruments HI 9141 - Manual (Page 11)

21 20
a - Current log number
b - Current sample number (in that log)
c - Date (DD-MM-YY)
d - Printing interval indicator in minutes
e - Time (HH-MM)
f - DO value in ppm
g - Temperature value
in °C
To continue logging without printing, press
CAL. The "LOG" symbol will start blinking
and no printout will be generated.
To restart printing, press the CAL key again.
Notes:
• Once in logging mode, the
interval cannot be changed.
First exit the logging mode
by pressing the LOG key,
then set the new interval.
• If PRINT is pressed while
in logging mode, a print-
out is produced without af-
fecting the running sample
number.
PRINT
CAL
LOG
LOG
To print the measured values
shown on display, press the
PRINT key.
This function can be activated in normal op-
eration mode as well as during logging.
When in measurement mode, the printout
provides the following information:
a - Current sample number
b - Date (DD-MM-YY)
c - Time (HH-MM)
d - DO value in ppm
e - Temperature value
in °C
LOGGING MODE
This function is suggested when remote mea-
surements have to be taken automatically
without the necessity of an operator and for a
long period of time. In this mode data will be
stored directly into memory.
Set the appropriate logging interval, then press
the LOG key to enter the logging mode. The
log number and page number will be dis-
played for a few seconds to indicate the
correct operational mode.
The printer will print a complete set of data
and the "LOG" symbol appears on the LCD.
The printout provides the following informa-
tion:
PRINT
PRINTING / LOGGING WITH HI 91410
a
b
c
d
e
1 4 - 0 1 - 9 6
0 0 0 1 * 1 6 . 5 0
8 . 9 5 p p m
2 0 . 4 ° C
<>
LOG
LOG
Log number
Page Number
1 4 - 0 1 - 9 6
- - 0 2 - - 0 0 0 5 M
0 0 0 1 * 1 6 . 5 0
8 . 9 5 p p m
2 0 . 4 ° C
<>
a
b
c
d
e
f
g
LOGGING MODE WITH PRINTING
This function is suggested when an immedi-
ate report of measurement is required in addi-
tion to the recording of the data into memory.
Press the LOG key. The log number and
page number will be displayed for a few sec-
onds on the display to indicate the correct
operational mode.