Hatteland Display 13 inch - HD 13T21 MMC (Widescreen, Inte Ato CPU) - Manual (Page 8)

DOC101014-1_Hatteland Display API_AIPC.docx rev: 7
Created: 17.11.2011 Modified: 07.10.2013 8 of 27
Hatteland Display AS, Åmsosen, N-5578 Nedre Vats, Norway
Tel: (+47) 4814 2200 - [email protected] - www.hatteland-display.com
Hatteland Display API
All intellectual properties belongs to Hatteland Display AS
Functions R/W Input Output Functionality
AIPC_CFG0_W WO 0xXX - Will write input data to the configuration
register 6 of PCA9555. The register configures
the direction of the I/O pins where a bit value
of 1 defines a pin as an input. The API default
value is 0xFF. (All pins are defined as input)
AIPC_CFG1_W WO 0xXX - Will write input data to the configuration
register 7 of PCA9555. The register configures
the direction of the I/O pins where a bit value
of 1 defines a pin as an input. The API default
value is 0x8F. (Pin 4-6 defined as output).
AIPC_Read_GPI RO - 1 byte Will read register 0 of PCA9555.
Bit 7 - If high, secondary power is present.
Bit 6 – If high, primary power is present.
Bit 5 – Digital Input (DI2)
Bit 4 – Digital Input (DI1)
Bit 3-0 – Reserved.
AIPC_K2_EN WO - - Will activate K2 relay, thus connecting pin
“COM” to “NO” on “X1-DIG-OUT” port (5 pins
connector).
AIPC_K2_DIS WO - - Will deactivate K2 relay, thus connecting pin
“COM” to “NC” on “X1-DIG-OUT” port. (5 pins
connector).
AIPC_HS1_EN WO - - Will activate HS1 switch, thus connecting
“Out+” to “OUT-“ on “X1-DIG-OUT”. Note that
HS_EN must also be active to achieve this.
AIPC_HS1_DIS WO - - Will deactivate HS1 switch, thus disconnecting
“Out+” from “OUT-“ on “X1-DIG-OUT”. Note
that HS_DIS will also deactivate HS1 switch.
AIPC_HS2_EN WO - - Will activate HS2 switch, thus connecting
“COM” to “NC“ on “X1-DIG-OUT” (4 pins
connector).
AIPC_HS2_DIS WO - - Will deactivate HS2 switch, thus disconnecting
“COM” from “NC“ on “X1-DIG-OUT” (4 pins
connector).
3.3 Watch Dog functions
3.3.1.1 Firmware
Functions
R/W Input Output Functionality
FIRMWARE_VERSION RO - 11
bytes Read the watchdog firmware version.
FIRMWARE_MODEL_NAME RO - 25
bytes
Returns firmware model name string of
unknown length. Length will normally be
shorter than 25 bytes.
3.3.1.2 Hardware information
Functions
R/W Input Output Functionality
HARDWARE_VERSION RO - 2 bytes The function can be used to check which
hardware is used, see table below. The function
will return the Data field. The value will differ
between the various hardware architectures.