Dpc-10, Dpc-10 software operating manual – HITEC DPC-10 User Manual
Page 5
5
Hitec Brushless Servo PC Programming Interface
DPC-10
DPC-10 Software Operating Manual
Automatic Sweep Positioning Test
The “Auto-Sweep” function will cycle a servo over and
over from end point to end point.
1. Select Sweep on the menu and click the “START”
button. The servo will then move from end point to
end point within its travel limits.
2. Use the slide bar next to the “START/STOP”
buttons to adjust the servo’s travel speed.
3. Click “STOP” to end the process.
Section 3
Click on the Set Position Buttons or move the slide
bar with your mouse to manually move your servo’s
position.
Note: You can use the Endpoint Slide Bars bar to set
the end points for both auto sweep and auto step
functions as described below.
Using the DPC-10 Test Functions
Manual Position Test
Position in µs
(900-2100)
Left End
Point Adjuster
Right End
Point Adjuster
Set Position
Buttons
Manual Slide Bar