JUGS Sports Combo (2 wheel) Pitching Machine - Manual (Page 17)

To Convert Setup from baseball to Softball Use
1. Place JUGS upside down, with tires flat on ground or floor and legs
pointing upwards.
2. Loosen Leg T-Clamp, which secures legs in place, and remove long legs
from sockets.
3. Place the curved ends of the three short legs in sockets so that the
distance between the legs is the same. (See Figure 4.)
4. Firmly tighten Leg T-Clamp to hold the legs in place very snugly.
5. Lift the pitching machine upright. Two legs should be facing toward the
batter, with one leg facing backward.
To switch from baseball use to softball use or vice versa, you must adjust the
distance between the tires and attach the appropriate-size ball-feed chute
assembly.
6. To adjust the distance between the tires, loosen and remove the two
locking knobs under the right wheel and ball feed chute.
7. After the lock knobs are removed, slide the right wheel away from the
left wheel and position the softball feed chute assembly so that its two
mounting holes line up with the two mounting holes on the pitching
machine. See red stripes on the casting for proper hole alignment. Insert
and tighten securely the two lock knobs into their appropriate mounting
holes. You are now ready to throw softballs.
NOTE:
To make the mounting of the ball feed chute assembly easier, always insert
and secure the lock knob located directly under the ball feed chute first before
inserting and securing the lock knob located under the right wheel.
15
Set Up