Kent Edg 28B - Manual (Page 19)

ENGLISH INSTRUCTIONS FOR USE
16 146 3082 000(2)2007-06 Edge 28B
DUST FILTER CLEANING AND INTEGRITY
CHECK, HOPPER GASKET CHECK
Drive the machine on a level ground.
Turn the main switch (1) to “0”.
Remove the hopper (9).
Loosen the knobs (A, Fig. 8).
Grasp the dust fi lter (B) as shown in the fi gure.
Remove the dust fi lter by turning it in the direction shown
by the arrow (A, Fig. 9) to disengage it from the pins (B),
then lower the fi lter to disengage it from the fi lter shaker
combs (C).
Remove the fi lter (A, Fig. 10) from the frame (B) by
disengaging the 2 rubber bands (C).
In an appropriate outdoor area, clean the fi lter by shaking
it on a level and clean surface, tapping the side (D)
opposite to the gasket (E).
Complete the cleaning procedure by using compressed
air (F) at maximum 87.0 psi (6 Bar), blowing only from
the side of the gasket (E), at a minimum distance of 11.8
in (30 cm).
Do not use water or detergents to clean it, otherwise it
can be damaged.
Check the fi lter body for tears. If necessary, replace it.
Clean the bearing surface of the fi lter rubber gasket
(E) and check it for integrity and sealing capabilities. If
necessary, replace the fi lter.
Clean the bearing surface of the hopper gasket (D, Fig.
9) and check it for integrity and sealing capabilities. If
necessary, replace it.
Assemble in the reverse order of disassembly.
NOTE
Assemble the fi lter with the gasket (E, Fig. 10)
positioned as shown in the fi gure.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
S311357
Figure 8
S311358
Figure 9
S311359
Figure 10
A
B
A
B
B
D
A
C
E
D
F
A B
C
C