Troubleshooting, Scrapping – Kent Edg 28B User Manual

Page 21

Advertising
background image

ENGLISH

INSTRUCTIONS FOR USE

18

146 3082 000(2)2007-06

Edge 28B

TROUBLESHOOTING

Trouble

Possible cause

Remedy

The machine does not start when turning the
main switch to “I” or to "II".

There is an open in a breaker (21).

Reset the breaker by pressing the relevant
button.

The battery charger cable is connected to
the electrical mains.

Disconnect it and place it in the housing.

The batteries are discharged.

Charge the batteries.

The side broom does not operate.

There is an open in a breaker (20).

Reset the breaker by pressing the relevant
button.

The machine operates only when stationary,
otherwise it turns off and the red warning
light fl ashes.

The batteries are discharged.

Charge the batteries. If the trouble persists,
have the batteries replaced at Kent Service
Center.

The battery autonomy is low.

The batteries are dead.

Have the batteries replaced at Kent Service
Center.

The batteries do not charge: the red warning
light (4) does not turn on when the plug is
inserted in the electrical mains socket.

There is no power supply at the electrical
mains socket.

Check the electrical mains socket by trying
to connect another domestic appliance.

For further information, refer to the Service Manual, available at any Kent Service Center.

SCRAPPING

Have the machine scrapped by a qualifi ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to
the Law in force:

Battery
Brooms
Plastic hoses and components
Electrical and electronic components (*)

(*) Refer to the nearest Kent Center especially when scrapping electrical and electronic components.




Advertising