Labconco Refrigerated CentriVap Centrifugal Concentrators 7310041 - Manual (Page 28)

Chapter 6: Accessories for Your CentriVap
Product Service 1-800-522-7658 24
remove the Quick Disconnect Coupling from the CentriVap when a vacuum
gauge is not attached to it.
Installing a CentriZap™ Strobe Light
An accessory strobe light is available to enable you to see the samples as they are
rotating in the rotor. Attach the holder to the right hand side of the CentriVap
Concentrator using the screws provided. Plug the connector on the strobe light
harness into the receptacle on the back of the CentriVap marked “STROBE
OUTLET.” Peel the protective backing off the enclosed Velcro® and attach it to
the back of the Concentrator. Secure the power supply box on the harness to the
Velcro. Place the light in the holder.
To use the strobe light while the CentriVap is operating, remove the light from its
holder, press the trigger and shine the light on the samples in the rotor.
*Velcro is a registered trademark of Velcro Industries B.V.