Labconco FreeZone Clear Stoppering Chambers User Manual
Page 11
7
Product Service: Domestic 1-800-522-7658, International 816-333-8811
C
C
H
H
A
A
P
P
T
T
E
E
R
R
2
2
P
P
R
R
E
E
R
R
E
E
Q
Q
U
U
I
I
S
S
I
I
T
T
E
E
S
S
Before you install your Clear Stoppering Chamber, you need to
prepare your site for installation. The Clear Stoppering Chamber
will mount on top of a FreeZone 6, 12 or 18 liter Freeze Dry
System. This could be either a benchtop or console model.
Carefully examine the location where you intend to install your
Clear Stoppering Chamber. You must be certain that the area is
level and of solid construction. An electrical source must be
located near the installation site.
Carefully read this chapter to learn:
• the electrical supply requirements.
• the vacuum pump requirements.
Refer to Appendix C: Clear Stoppering Chamber Specifications for
complete Clear Stoppering Chamber electrical and environmental
conditions, specifications and requirements.
Refer to the User’s Manual for the FreeZone Freeze Dry System
for complete electrical and environmental conditions,
specifications and requirements.
Electrical Requirements
The Clear Stoppering Chamber requires a dedicated electrical
outlet. This outlet requires a 15 Amp circuit breaker or fuse for
models rated at 115V (50/60 Hz). An outlet equipped with a 8
Amp circuit breaker or fuse is required for models rated at 230V
(50/60 Hz). The power cord on 115V models is equipped with a
15 Amp NEMA 5-15P plug. The power cord on 230V models is
equipped with a CEE 7/7 plug. If this does not match with the
available receptacle, remove this plug and replace it with an
approved plug of the suitable style.