Labconco FreeZone Clear Stoppering Chambers - Manual (Page 15)

11
Chapter 3: Getting Started
Product Service: Domestic 1-800-522-7658, International 816-333-8811
Setting Up Your Clear Stoppering
Chamber
After you verify receipt of the proper components, move your
Clear Stoppering Chamber to the location where you want to
install it. Then, follow the steps listed below.
Installing the Clear Stoppering Chamber
on the Freeze Dry System
1. Place the rubber gasket over the 3” port on the top of the
Freeze Dry System.
2. Position the Shelf Assembly over the 3” port. Rotate the
Shelf assembly so it clears the lid over the collector.
3. Place the clear chamber over the shelves.
4. Position the Stoppering Assembly on top of the chamber.
Make sure the tab on the bottom plate is not positioned
directly above the pin on the shelf assembly top plate.
Rotate the entire stoppering assembly clockwise until all
3 tabs with slots fully engage the 3 rods.
5. Position the Power Supply on the top of the Freeze Dry
System and then connect the harness from the Shelf
Assembly to the Power Supply.
)