Laerdal AT Kelly Torso - Manual (Page 8)

• Trim bladder tubing to match original tubing length to
fit this manikin style. Insert new pneumothorax
bladder into site cavity and reposition hose under
cable tie.
• Reconnect hose to inline hose connector.
• Replace foam pads over pneumo bladders.
• Secure Velcro® strap to chest plate with screws
removed previously.
• Return chest plate to proper position on torso.
• Replace chest skin over torso, being sure to secure
skin at shoulders.
( B) Bilateral Mid-Axillary Sites:
• Remove chest skin from torso.
• Remove pneumo pad from side of torso. (Figure 2)
• Disconnect bladder hose from inline hose connector,
being sure hose does not fall through hole and into
torso.
• Remove bladder from pneumo pad and discard.
• Trim bladder tubing to match
original tubing length to fit this
manikin style. Connect new
bladder hose to inline hose
connector.
• Insert new pneumo bladder into
pneumo pad.
• Replace chest skin over torso,
being sure to secure skin at
shoulders.
Fig. 2
Central Vein Cannulation:
Two central veins may be cannulated: internal jugular (central
approach only) and subclavian.
1. Attach IV bag and tubing to central vein tube located
on right side of manikin. (It is in same location as
blood pressure bulb and carotid pulse bulb).
2. Fill IV bag with desired amount of fluid and infuse.
3. Aspirate line using a needle and large syringe until
fluid is drawn.
To remove, reverse procedure.
260-00001 Laerdal 8