Laerdal Extri Kelly - Manual (Page 6)

Arms: Arms are attached
Laerdal Recommends
Attachment hardware is
located in envelope in box.
using a 4 ½ inches long bolt, three
washers, a spring and a wing nut.
To attach:
1. Remove chest plate from
manikin to locate hole in shoulder.
2. Remove deltoid injection pad from arm by squeezing
skin in center of pad while pulling
3. Slide washer over bolt.
4. Insert bolt through hole in arm and then through
hole in the manikin’s shoulder.
5. Slide one washer, a spring, a second washer and a
wing nut over bolt.
6. Use screwdriver to hold bolt steady while tightening
wing nut. (See Fig. 1)
To remove arms, reverse procedure.
Fig. 1
Legs: Legs are attached using a 6 inches long bolt, a
spring, a large washer, a small washer and a wing nut.
To attach:
1. Remove belly plate from manikin to locate hole in
hip.
2. Remove thigh injection pad from leg by squeezing
skin in center of pad while pulling.
3. Slide spring and small washer over bolt.
4. Insert bolt through hole in pelvis.
5. Slide large washer and wing nut over bolt.
6. Use a screwdriver to drive bolt into wing nut. (Fig. 2)
7.
101-10001 Laerdal 6