Laerdal In-Service Home Care Training Simulator - Manual (Page 5)

Abdominal Module:
The abdominal module fits into the lower torso by means of
a ledge on plate and corresponding groove on torso cavity.
To Remove:
Apply pressure to center of the plate, while working your
fingers under edge of the plate and lifting out.
To insert:
Position the plate over the cavity and work the edges into
the groove on the torso cavity.
The abdominal module also contains the urinary reservoir
and colostomy stoma.
To fill the reservoir:
Remove the colostomy stoma on left side, fill reservoir and
reinsert stoma.
Injection Pads:
Squeeze pad together with fingers and pull out to remove.
To replace, reverse the procedure.
Hip Joints:
The hip joints are attached using a bolt, a spring, two
washers and a wing nut.
To attach thighs:
1. Locate envelope containing attachment hardware.
2. Remove abdominal module from module to locate
hole in the hip.
3. Remove thigh injection pad.
4. Slide a spring and washer onto the bolt and insert
bolt through hole in the pelvis.
5. Slide the washer and the wing nut over the bolt. Use
a screwdriver to drive the bolt into the wing nut
(Figure1).
To remove the thighs, reverse the procedure.
6.
Fig. 1
375-20001 Laerdal 5