Laerdal LGH MamaNatalie - Manual (Page 4)

6 7
3 Detach the Simulation Tubes
The Simulation Tubes are attached to the right side
of NeoNatalie’s chest. Pull gently on the Tubes to
release them.
Tip: After delivering NeoNatalie, reattach the Simulation
Tubes to simulate spontaneous breathing and palpable
umbilical pulse.
4 Attach the Umbilical Cord
Connect the Umbilical Cord from the Placenta
to NeoNatalie by clicking the two connectors
together.
Tip: To detach the cord, break the connection
point with your thumbs as shown in the
illustration above.
To Prepare MamaNatalie
li li li li
1 Inflate the Uterus Air Reservoirs
The Uterus contains two reservoirs. Air can be
manipulated from one reservoir to another to
simulate various uterus conditions.
a) Open the Air Valve.
b) Use the NeoNatalie Suction to inflate the
Uterus Reservoirs with air. Adjust the amount
of air until you pass the test for correct inflation
level (as described on the next page).
c) Close the Air Valve.
Test for correct inflation level:
A B
A B
a) Compress Uterus Air Reservoir A with your
hand. Reservoir B should feel firm to simulate
a contracted uterus.
b) When the grip on reservoir A is relaxed, air is
distributed between both Uterus Air
Reservoirs A and B. Reservoir B should now
feel like a soft uterus.
2 Fill the Blood Tank
ite r lit e l
a) Check that the Blood Valve of the Blood
Tank is closed.
b) Ensure that the blood tube is connected
to the blood nipple on the back side of the
Skeleton.
lit er
c) Mix artificial blood according to
manufacturer’s instructions. Unscrew the
Blood Tank Cap and fill with the desired
amount of artificial blood (up to 1.5 liters).
Return the Blood Tank Cap.