LG Motorsports LG G5 Sway Bars - Manual (Page 5)

Figure 5: New rear sway bar installed, shown with optional HD links and Super Springs
Installing of the front bar is going to be basically the same as the removal. Start
by rotating the bar and walking it though and over the frame. We have found it easier to
set the bar in place without the bushings on. Now that the bar is in place, again remove
the bushing hold downs from the bushings. Snap the bushings over the bar and slide on
the outside of the centering rings on the bar. Once the bushings are in place, place the
hold downs over the bushings and re-use the stock bolts to attach the bar to the car.
Again blue locktite is recommended for these bolts.
Those installing factory end links, place the links into the desired hole, install nut
and tighten. Those installing the optional HD links please install as shown below in the
diagram. Leave these bolts finger tight until the end. Please see special setup note for
end link setup at the bottom of the instructions.
These are adjustable sway bars to make the sway bars stiffer move your end links
to the inner holes, to soften the bars move to the outer holes. We suggest moving both
sides at the same time for most consistent results. Most will start the bars out equally in
the middle holes for general street and spirited driving.