LG Motorsports LG G5 Sway Bars - Manual (Page 6)

Figure 6: Front sway bar installed (with HD links installed)
End Link Adjustment:
Those that purchased the optional HD end link kit can benefit from a more precise
setup of your sway bars. Not only can you adjust the stiffness of the bar, but with the HD
links you can now ‘zero’ your sway bars. To do this you must have the car on the ground
at ride height or on a wheel style lift so the suspension is loaded. Adjust one side of your
end links to make the arms of the sway bars parallel with the ground. Once you have one
side length set, tighten the jam nuts and tighten the bolts holding the link to both the bar
and the control arms. Now the position of the bar is set, move over to the other end link.
You will need to adjust the length of this link so that the bolts freely move in and out of
the sway bar so there is no load being placed on the bar at rest. Set the jam nuts and
tighten the bolts holding the link to the bar and control arms. Now your sway bars only
act on the car when the car is loaded in a corner and it will react the same in both left and
right corners as the bar will not have a bias to one side or the other.