LG Motorsports LG G5 Chassis Brace User Manual
Page 4
Figure 3: Install of outer nut plate.
Install the plate by twisting the plate through the larger open slot to align with the middle
hole. The bent down tab will hold the plate while you tighten the bolts.
Next we will install the two front nut plates by sliding into the open section of the
factory car chassis rails. Notice that there is one open hole in the plate. This hole will go
over the factory nut shown in the picture below with the green tape. This plate will serve
to hold the front of the rear bars as well as the start of the mid plate bars in place.
Figure 3: Front nut plates install.
Now that the plates are installed you can start to begin the install of your rear
brace. Support the brace using a floor jack, transmission stand (shown in figure 2), or
friend. At the rear of the brace install the 12mm x 1.75 x 60mm bolts, washers, and ny
lock nuts. There will be two per side that go through the brace and into the rear
subframe. Loosely screw on the nuts, we will tighten when everything is installed.