LG Motorsports LG G5 Chassis Brace - Manual (Page 6)

Figure 6: Outer brace bolt installed
Moving forward yet again we are going to start the install of the front bolt
locations, see figure #7. In these holes we will be using the 10mm supplied bolts and a
combination of factory nut locations as well as the installed nut plate that we installed in
figure 3 above. Remember use a correct washer at each location. The factory cross brace
will also be used at this time (removed for picture). Leave the furthest forward bolt out
as the mid bars will connect at this location. If you only purchased the rear braces, at this
time install the front bolt, and tighten all bolts working from the middle out. For those
that purchased the entire kit, please proceed, again leaving all bolts at this time only hand
tight.
Figure 7: Front location hold down (Stock cross brace removed for picture)