Lingenfelter L300080607 Lingenfelter Suburban Yukon Aux Fan Kit AC Clutch Control 2005-07 vE - Manual (Page 12)

Page
38. On the terminal side of the green wire,
strip back the insulation 5/16”.
Insert the wire into the smaller side of the
connector, make sure the wire is properly
seated and crimp the connector using an
insulated connector crimping tool.
11.
39. Apply heat evenly around the length of the
tubing (including the crimp area) from the center
out to the ends until the tubing fully recovers
and the adhesive flows. During the heating
process, separate the two wires in the larger
end of the connector to allow the adhesive to
flow in between the wires.
40. Remove from the heat and let cool.
37. Method A (for method B, skip to step 41)
Cut the green wire that connects to pin D4
roughly 1-1/2” away from the terminal.
Strip back the insulation 5/8” on the harness
side of the green wire and also the orange fan
harness wire and insert the two wires into the
larger side of the supplied crimp connector (PN
DC-940010). Make sure that both wires are
properly seated and crimp the connector using
an insulated connector crimping tool.