Lingenfelter L300080607 Lingenfelter Suburban Yukon Aux Fan Kit AC Clutch Control 2005-07 vE - Manual (Page 8)

Page 7.
21. Mount the supplied fuse block to the
inside of the driver side front fender by drilling
two holes (1/8” drill) through the fuse block
mounting tabs. Be careful not to drill too far
or you risk damaging the outer fender. Now
using a Phillips head screw driver secure
the fuse block to the vehicle with the two
M4.2x1.41x20mm Phillips head self tapping
screws.
22. Mount the relays to the left-hand side
(driver side) of the upper fan shroud by drilling
two 1/4” holes into the plastic shroud and
securing with the supplied push-lock rivets.
24. Apply the fuse panel decal to the fuse
panel cover as shown. Now connect the two red
fan harness power wires to the fuse block you
installed in step 21. The red wire with the #3
on it, labeled fan #1, goes into the #2 position
on the fuse block (labeled Aux FAN1) and the
other red power wire goes to the #1 fuse block
position (labeled Aux FAN2).
NOTE - if you will be installing additional
accessories using the supplied fuse block, the
maximum fuse block capacity is 65 amps.
23. With the relays mounted, route the red
power wires up and behind the windshield
washer bottle and over to the 6 position fuse
block.