Lingenfelter L500151410 Lingenfelter - Pedders Camaro SS Coil Over Shocks - Manual (Page 4)

www.PeddersUSA.com
248.522.8021
Camaro 160086
Xa Coilovers
11. Remove the strut and mark left and right. They are not interchangeable.
12. The upper strut mount, upper washer, and strut bearing must be transferred to the
new Xa assembly. To disassemble, first note the upper washer is like a bowl and must
be reinstalled this exact way! The bottom washer and the coil insulator are NOT re-
used.
13. With a 19mm wrench, disconnect the upper red adjuster on the Xa strut and dispose
of the cardboard piece.
14. The picture on the right shows the assembly as it is installed on the Xa coil over.
Install all the components on the right less the spring insulator highlighted which you
will dispose, in the order shown, onto the Xa coil over, and tighten by hand the top-
retaining nut (24mm) you can use a 5mm Allen socket to help you secure the nut.
But final tightening will be done on the car and later. Make sure the nut is at least
seated
The OEM Upper front strut
coil insulators should be
discarded. There are two
types: black rubber and beige
urethane foam.