Luxul XAP-1500 - Manual (Page 27)

27
User Guide
© 2014 Luxul. All Rights Reserved.
Other trademarks and registered trademarks are the property of their respective owners
RF Exposure Guidelines
Safety Information: The device complies with internationally recognized standards covering human
exposure to electromagnetic fields from radio devices.
Warning: Exposure to Radio Frequency (RF) Radiation:
The radiated output of this device is below the FCC radio frequency exposure limits. Nevertheless, the
device should be used in such a manner that the potential for human contact during normal
operation is minimized.
„ The end user must avoid any extended human RF exposure directly in front of the device, up to a
distance of 20cm, when unit is on.
„ When servicing the equipment and selecting a location for the antennas, it is important to note that a
minimum distance of 20cm is required between personnel and the device or antenna to comply with
the radio frequency exposure limit.
„ The antenna used for this transmitter must be installed to provide a separation distance of at least
20cm from all persons and must not be co-located or operating in conjunction with any other
antenna or transmitter.
The following safety precautions should be observed:
„ Do not touch or move the antenna while the unit is transmitting or receiving.
„ Do not hold any component containing the radio such that the antenna is very close or touching any
exposed parts of the body, especially the face or eyes, while transmitting.
„ Do not operate the radio or attempt to transmit data unless the antenna is connected; this behavior
may cause damage to the radio.
Remote and Standalone Antenna Configurations: To comply with FCC RF exposure requirements,
antennas that are mounted externally at remote locations or operating near users at stand-alone desktop
of similar configurations must operate with a minimum separation distance of 20 cm from all persons.
FCC Statement—Wireless FCC 2.4GHz 802.11bgn
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Radio Frequency Interference Requirements—FCC
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
„ Reorient or relocate the receiving antenna
„ Increase the separation between the equipment and receiver