Luxul XAP-1500 - Manual (Page 4)

4
XAP-1500
a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | luxul.com | 801-822-5450
LUX-UG-XAP-1500 Vers: 07314
1 INTRODUCTION
Congratulations on your purchase of the Luxul XAP-1500 - High Power Dual-Band
Wireless Low Profile Access Point. The XAP-1500 is designed for use in residential and
commercial Wi-Fi installations—delivering optimal wireless network performance. With
this high powered, concurrent dual-band wireless access point, wireless devices that
are compatible with 802.11a/b/g/n can sustain high data rates and improved overall
performance at significantly greater distances.
The XAP-1500 features Luxul’s web based management interface. provides a simple
method for setting up the wireless network. The XAP-1500 is also enabled for instal-
lation simplicity when installed with Luxul Routers, Gigabit Switches, and other Luxul
products.
XAP-1500 Features:
„
Highest FCC Approved Performance (Effective EIRP 36dBm) for Farther Reaching
Signal and Maximum Data Rates
„
Complies with IEEE 802.11n Standard. Backward Compatible with IEEE 802.11a/b/g
„
Supports WMM QoS Functionality to Prioritize Multimedia Traffic
„
Enhanced Multi-Level Security with WPA-PSK (TKIP, AES, TKIP & AES), WPA2-PSK (AES),
WPA-PSK/WPA2-PSK Personal (TKIP & AES) and 128-bit WEP
„
Supports up to 12 SSIDs - 6 on 2.4GHz and 6 on 5GHz with Individual Security Settings
„
Multiple SSIDs Support with VLAN Tagging (1 VLAN per SSID)
„
Single Cable Installation with PoE (requires the use of enclosed injector)
„
Firmware Upgradeable
„
Easy 3 Step Setup through Web-based User Interface
„
Enabled for Maximum Compatibility and Performance with
other Luxul Products
„
Install on Wall, Ceiling or Desktop
1.1 Warnings
„
Read all installation instructions and site survey reports, and verify correct equip-
ment installation before connecting this device to its power source.
„
Connect all power cords to a properly wired and grounded electrical circuit.
„
Verify that the electrical circuits have appropriate overload protection.
„
Verify there is adequate ventilation around the device, and that ambient tempera-
tures meet equipment operation specifications.
„
Products outside the approved configurations may be in violation of Part 15 of the
FCC Rules.