LW Measurements LCT 110 - Manual (Page 19)

19
4.2.2.7 Activating the acoustic signal
When the scale is turned off, press and hold [UNIT WEIGHT] key to turn on the scale, press [QTY/SET]
to select activate(b-ON) or inactivate(b-OFF) the function of the beeper.
4.2.2.8 Activating the display backlight
When the scale is turned off, press and hold [UNIT WEIGHT] key to turn on the scale, press [ZERO] key
to select L-ON, L-AU(for auto) or L-OFF for the backlight function.
4.2.2.9 Automatic stand-by
When the scale is turned off, press and hold [UNIT WEIGHT] key to turn on the scale, press [TARE] to
select automatic stand-by time
.
4.2.2.10 Memory storage

Turn on the scale. Select the unit (kg or lb) for the storage of unit weigh by pressing
[SAMPLE/UNIT] key.

Key in the unit weight value through data 0~9, then press [STORE] to confirm the unit weight.
 The display will show “c xxx”.
 Within 2 seconds, press M1, then the third line of the display will show “- - - -”.

The memory storage for M1 is complete.

Press [CE] to clear the memory, the second line of the display will show 0.

Repeat steps above, to store memory values for M2~M9.

Press M1 to M9 to recall each pre-stored unit weight from memory.
4.2.2.11 Total weight clear
After accumulation was done through [M+], to clear the total pieces,

Press [TOTAL] to show total pieces on the third line of the display.

Press [MC] to clear the showed total pieces.

Press [CE] to confirm.