Mossberg 59 Line Launcher - Manual (Page 5)

5
Unscrew the line canister lid. Uncoil approximately 4 feet of the outer coil line’s
“stationary” end. With the “inside” line end positioned forward, place the coil into the
canister threading the “outside” line through the slot on the left side of the canister.
Keep the muzzle in an upright position. Attach the 4 foot stationary line end to a
hauling line.
Remove 12 inches of line from the inside coil “traveling” end. Thread the 12 inch
traveling end length through the canister lid hole and hand tighten the canister lid to
the canister.
Attach the 12 inches “traveling” line to the shaft with a uni-knot.
Loading the Projectiles
Keeping the muzzle pointed in a safe upward direction, slide the projectile fully
into the barrel. The shaft is equipped with an O-ring near the base of the shaft to
help prevent the shaft from sliding forward off the face of the blank load. The
depth warning indicator on the shaft should not be visible.
Canister
lid
Ł