NEMO Equipment MET 1P - Manual (Page 5)

®
Insert Trekking Pole
Slide the handle of the trekking pole into the reinforced pocket at
the top of the tent. Insert the trekking pole tip into the grommet
near the center of the door.
Stake Corners
Secure the corner anchors by pounding the stakes into the ground
with a rock or hard object. If the ground is too hard, tie the anchors
to a rock or another heavy object.
Connect Vestibule
Connect side release buckle on the vestibule to the end of the front
webbing anchor.
Extend Trekking Pole
Extend the trekking pole upwards and stake the rear vent. Adjust the
vestibule tension to ensure maximum water shedding and wind resistance.
Locate rear anchor (beneath the rear vent) and stake into place.
Tension webbing strap straight out from the center of the door,
making sure not to distort the bottom of the tent. Stake in place.
Stake Webbing Strap and Rear Anchor
Remember to leave no trace. Before leaving your campsite, take a thorough look
around making sure you have not left anything behind, out of place, or damaged.
To contact NEMO Customer Service
Email: [email protected]
Phone: 800-997-9301
META ™ 1P
INSTRUCTIONS FOR SETUP
1
2
3
4
5
©2012 NEMO Equipment, Inc.