NEMO Equipment META 1 - Manual (Page 4)

Setup Guide
1. Secure the corner anchors by pounding the stakes into the ground with a
rock or hard object. If the ground is too hard, trap the stakes under a rock
or another heavy object.
2. Locate the rear anchor (beneath the rear vent) and stake into place.
Tension the webbing strap straight out from the center of the door,
making sure not to distort the bottom of the tent. Stake the webbing
strap anchor in place.
3. Slide the handle of the trekking pole into the reinforced pocket at the top
of the tent. Insert the trekking pole tip into the grommet near the center of
the door. Extend the trekking pole upwards.
4. Connect the side release buckle on the vestibule to the end of the front
webbing anchor. Stake the reflective rear vent cord to maximize airflow.
Adjust the rear vent and vestibule tension to ensure maximum water
shedding and wind resistance.