NEMO Equipment META 1 - Manual (Page 9)

®
Insert Trekking Pole
Slide the handle of the trekking pole into the reinforced pocket at
the top of the tent. Insert the trekking pole tip into the grommet
near the center of the door.
Stake Corners
Secure the corner anchors by pounding the stakes into the ground
with a rock or hard object. If the ground is too hard, trap the stakes
under a rock or another heavy object.
Connect Vestibule and Stake Rear Vent
Connect side release buckle on the vestibule to the end of the front
webbing anchor. Stake the reflective rear vent cord to maximize airflow.
Extend Trekking Pole
Extend the trekking pole upwards and adjust the rear vent and vestibule
tension to ensure maximum water shedding and wind resistance.
Locate rear anchor (beneath the rear vent) and stake into place.
Tension webbing strap straight out from the center of the door,
making sure not to distort the bottom of the tent. Stake in place.
Stake Webbing Strap and Rear Anchor
Remember to leave no trace. Before leaving your campsite take a thorough look
around making sure you have not left anything behind, out of place, or damaged.
©2010 NEMO Equipment, Inc.
1
2
3
4
5
To contact NEMO Customer Service
Email: [email protected]
Phone: 800-997-9301
META 1P ™
INSTRUCTIONS FOR SETUP