Nor-Cal Intellisys Throttling Pendulum Valve - Manual

Intelli sys Pendulum Valve Quick-Start Guide
200mm, 250mm and 350mm Isolation and Throttling Pendulum Gate Valves
Nor-Cal Products, Inc. 1967 South Oregon St., Yreka, CA 96097 USA
LIT-PV-QSG, 01/2005
Unpacking & Handling
Use care when unpacking an Intellisys Pendulum Valve. Never lift by the Actuator or Motor. Lift only by the
body edges. Aluminum surfaces can scratch easily. A static-safe, particle-free work surface is recommended.
There is no need to remove parts during installation or inspection.
Check The Package Contents:
•
Intellisys Isolation (IPV) or Throttling (TPV) Pendulum Valve
NOTE: IQ-series controllers are mounted directly to the TPV actuator
•
This Quick-Start Guide
Serial Label
A Serial Label on the bag shows the model number and serial number of your product. Additionally, Model,
Serial and Date Codes are engraved, and an inspection sticker is affixed to the side of the valve.
Warranty
Nor-Cal Intellisys Controllers and valves are warranted against defects and material workmanship for a period of
12 months after the date of shipment to the buyer. For complete warranty and Intellectual Property details,
please refer to the full manual.
Pre-Installation Functionality Check
Refer to the diagrams & photographs on the back of this sheet for locations of the items that follow.
WARNING: The valve plate movement presents a severe pinching/crushing
hazard. Please keep fingers, hands and other objects away from the valve
opening and associated moving parts.
Pneumatic Isolation Pendulum Valves (IPV)
Connect the Pneumatic Line
For pneumatically driven IPV valves, connect an unpressurized CDA or N
2
line to the input solenoid then slowly
bring up the pressure to 80PSI.
Open and Close Testing
To open the valve, manually depress and hold the small orange button on the solenoid near the CDA input.
Release the button to close the valve.
Motor-Driven Throttling Pendulum Valves (TPV)
Connect Power and Valve Cables
Connect the APC controller to the valve motor with a Nor-Cal TBV-CRD series cable. (NOTE: IQ-series valves
do not require a valve cable connection, as the motor is integrated into the controller.) Connect the controller to
an appropriate power source. Toggle the power switch (if applicable) or apply DC power from your source.
Initialize the Valve
From the tool software, send the appropriate initialization command to begin initialization. During Initialization,
the valve will complete a 30-second initialization sequence during which the valve plate will cycle back-and-forth
several times. The valve will eventually stop in the open position, unless specified otherwise by the firmware.
Open/Close Testing
Verification of the system communications can be done by toggling the “OPEN / CLOSE” switch (if available) on
the controller front panel, or sending the appropriate command from the tool software. If the valve does not
operate as described, please contact Nor-Cal technical support.
Obtaining Complete Manuals
Complete manuals for Intellisys Pendulum Valves can be downloaded from our website, www.n-c.com .
To download complete manuals for Intellisys Pendulum Valves, please visit www.n-c.com . Click Support,
choose Product Documentation Downloads from the drop-down menu, and pick Downstream Pressure
Control and locate document under Manuals at the left.
Serial Label
Body Engraving Inspection Sticker