Dish Network 6.3 - Manual (Page 16)

4
S CANNING FOR E QUIPMENT C ODES
5 Enter one of the three-digit
equipment codes from the
table using the number
buttons.
The three-digit equipment code
should be for the brand name of
your equipment that you found
in step 2.
6 If you want to program
Limited Mode, press 1.
If not, skip to step 7.
See Limited Mode on page 3 for
more information.
7 Press POUND (#). If you entered the code
correctly, the mode button
flashes three times.
8 Press POWER to turn off
the equipment. If the equip-
ment does not turn off, go
to step 10.
If the code works, the
equipment should turn off.
9 Turn the equipment back
on and try some other but-
tons to make sure they
work. If the code works for
other buttons, stop here.
For example, sometimes
POWER works when other
buttons don’t.
10 If the code doesn’t work,
repeat steps 3 through 9
with another equipment
code from the tables.
Try every code listed for your
brand until one works for your
equipment.
11 If you can’t find a code that
works, try Scanning for
Equipment Codes that
follows.
Instructions Additional Information
1 Turn the equipment on. Use the equipment’s front panel
buttons or its remote control.
Instructions Additional Information
6.3 Replacement.book Page 4 Tuesday, November 7, 2006 11:56 AM