Dish Network 6.3 - Manual (Page 18)

6
S WITCHING B ETWEEN TV AND A MPLIFIER V OLUME
C ONTROL
When you set up the remote to control a TV, the MUTE and VOLUME
buttons control the TV volume, even if your remote control is in SAT
mode. However, if you want to use the AUX mode to control a tuner or
amplifier that has a volume setting, you can set up the remote to control
the equipment’s volume instead of the TV volume while your remote
control is in SAT mode. Follow the instructions in the left column. To
change back to controlling the TV volume in SAT mode, follow the
instructions in the right column.
8 If necessary, repeat this
procedure until you’ve tried
all the codes.
You may need to repeat the
scan to find the best code for
your equipment.
Control Amplifier Volume Control TV Volume
1 Press and hold the AUX
mode button for three sec-
onds, and then let go of it.
The AUX mode button will
blink.
1 Press and hold the TV
mode button for three sec-
onds, and then let go of it.
The TV mode button will
blink.
2 Press the POUND (#) but-
ton.
2 Press the POUND (#)
button.
3 Press the plus (+) side of
the VOLUME button.
3 Press the plus (+) side of
the VOLUME button.
4 Press the 0 number button. 4 Press the 0 number button.
5 Press the POUND (#) but-
ton.
5 Press the POUND (#)
button.
The AUX mode button
flashes three times. The TV mode button
flashes three times.
M AKE SURE THE REMOTE
CONTROLS THE AMPLIFIER ’ S
VOLUME :
M AKE SURE THE REMOTE
CONTROLS THE TV’ S VOLUME :
6 Press the SAT mode but-
ton.
6 Press the SAT mode but-
ton.
Instructions Additional Information
6.3 Replacement.book Page 6 Tuesday, November 7, 2006 11:56 AM