ParkZone PKZ5280 - Manual (Page 9)

1. Guide the left and right aileron servo connectors from the
bottom of the wing into the top of the fuselage.
2. Attach the two (2) aileron connectors to the aileron
Y-harness in the fuselage.
Note: There is no difference between the two connections on
the Y-harness. Left and right servo connectors do not have to be
connected to a particular side of the Y-harness.
3. Guide the leading edge of the wing into the retaining clip
on the cockpit windshield.
4. Attach the wing to the fuselage using two (2) screws.
5. Install left and right struts in fairings in the lower fuselage
using two (2) RC body clips or two (2) L-pins.
Note: The clips and L-pins are provided to support disassembly
for storage. Finish on L-pins or body clips may not match
photos.
6. Gently lift the left side of the wing and install the left wing
strut in the fairing under the wing.
7. Gently lift the right wing and install the right strut.
8. Attach the wing struts to the fairings under the wing using
two (2) RC body clips or two (2) L-pins.
9. Where used, apply tape to the four (4) L-pins to hold them
on the struts.
Installing Wings
Note: When the aircraft is frequently disassembled for travel,
use of body clips is recommended. Although the L-pins provide
a more finished appearance, they require tape for installation
and are not as easily removed as the body clips.
EN
8 9