ParkZone PKZ5680 - Manual (Page 10)

EN
Nose Wheel
1. Remove and retain screw (A) from nose wheel pant (B) and nose wheel (C).
2. Remove wheel from nose wheel pant.
3. Install wheel and screw in nose wheel pant.
B
A
C
Assembly
1. Assemble model by obeying instructions above in reverse.
2. Make sure propeller size numbers (6 x 6) face the motor.
3. Use a small amount of clear tape to hold the motor wires on the fuselage.
Make sure no wires are pinched or damaged when the rear hatch is
installed on the fuselage.
CAUTION: DO NOT handle the motor or ESC while the fl ight battery is
connected to the ESC. Personal injury could result.
N
K
J H
M
G
F
E D
Note: Not all wiring shown.
Service of Power Components
Disassembly
1. Remove front canopy (A) from fuselage.
2. Disconnect battery from ESC.
3. Remove battery from hook and loop straps in fuselage.
4. Loosen screw (B) and remove rear hatch (C) from fuselage.
5. Disconnect 3 bullet connectors of motor from ESC connectors (motor wire
colors align with ESC wire colors).
6. Remove spinner nut (D), propeller (E), backplate (F) and collet (G) from
motor shaft.
Note: A tool may be needed to turn spinner nut.
7. Remove 4 screws (H) and 4 silicone spacers (I) from motor mount (J) and
fi rewall of fuselage.
8. Remove 4 screws (K) and 4 lock washers (L) from motor mount (J) and
motor (M).
9. Remove ESC (N) from hook and loop strap and fuselage.
A
C B
I
L
10