ParkZone PKZ5680 - Manual (Page 6)

EN
Installing Vertical Fins
Assembly
1. Apply double-stick tape (A) to the bottom of each vertical fi n (B), in front of
the rudder hinge.
2. Carefully trim the excess tape (using a sharp hobby knife blade or scissors).
Note: Make sure tape does not go past rudder hinge.
3. Carefully put left vertical fi n under fairing and in left housing (C) on the
fuselage. Rudder control horn is on inner side and Stryker decal is on outer
side of vertical fi n).
4. Install right vertical fi n using double-stick tape.
5. Install linkages (D) on servos (E) then attach clevises (F) to control horns (G).
H
C
B
A
D
E
F
G
Note: Before fl ying the model in extreme high-speed
maneuvers, apply CA (H) where the vertical fi n connects
with the fuselage housing.
1 3 4 2
• Lower throttle and
throttle trim to
lowest settings.
• Connect battery to ESC. Continuous LED
Series of tones
• Power on ESC switch.
Power on
Transmitter
Wait 5
seconds
Before Flight
NOTICE: Use of CA accelerant on your model can damage paint. DO NOT wipe accelerant from model, but let accelerant evaporate.
6
Installing a Receiver
Battery Selection and Installation
1. Install your park fl yer or full range receiver in the fuselage using hook and
loop tape or double-sided servo tape.
2. Attach right aileron to elevator channel of your receiver. Left aileron goes
to aileron channel of your receiver. You will also need to activate the delta
wing/elevon confi guration of your transmitter.
Note: If using a DX5e or DX4e transmitter, this is the ‘mix’ function on the
front of the transmitter. For specifi c set-ups for JR/Spektrum 6+ channel
transmitters, see “Transmitter and Model Set Up” section.
3. Attach the ESC connector to the throttle channel of the receiver.
1. We recommend the ParkZone 2200mAh 11.1V 25C Li-Po battery (PKZ1029).
2. If using another battery, the battery must be at least a 25C 2100mAh battery. 3. Your battery should be approximately the same capacity, dimensions and
weight as the ParkZone Li-Po battery to fi t in the fuselage without changing
the center of gravity a large amount.