RODE Microphones NT3 - Manual (Page 8)

- 8 -
• A stand mount clip (RM3) is included with your
NT3, and should be used to connect the NT3 fi rmly
and safely to a stable microphone stand.
• Always use a high quality microphone cable and
ensure that it is wired Pin 1 screen, Pin 2 (+), Pin 3 (-).
You may of course use XLR-XLR, XLR-jack or XLR-
mini-jack depending on your input socket.
• We recommend that any connections made to the
mixer or recorder are made with the attenuation
(gain) set to OFF.
• When fi rst switching the mixer on and phantom
power has been applied to the NT3, or when the
battery power has just been switched on, you
should allow several seconds for the microphone to
stabilize.
• To ensure the lowest noise/distortion your mixer
input gain control should be set so that the Peak
Program Indicator (PPI) LED fl ashes ON during
peaks of the source (voice/instrument).
If there is no PPI, adjust the input gain while
listening for distortion of the sound. If distortion is
heard, gradually reduce the gain until it is no longer
present.
• Microphone technique, or how to get the sound
you want, requires experimentation.
We suggest that you start with the channel EQ
set to ‘OFF’ or ‘FLAT’ (no boost or cut). Try to get
the sound you want by placing either refl ective or
absorbent panels at various angles adjacent to the
source being recorded.
Using the NT3