Remy REPLACING 50DN ALTERNATOR SHAFT SEAL AND O-RING - Manual (Page 2)

Technical support: USA 800 854 0076, Mexico 01 800 000 7378, Brazil 0800 703 3526, South America 55 11 2106 6510 or visit
delcoremy.com
NOTICE - Only licensed Remy International, Inc. product and component parts should be used, and the use of other parts or modifications not approved
by Remy International, Inc. will void all applicable warranties. The failure to carefully follow these Installation Instructions, set forth above, will void all
applicable warranties. DELCO REMY is a registered trademark of General Motors Corporation, licensed to Remy International, Inc. Pendleton, IN 46064.
©
2012 Remy International, Inc. All rights reserved 2
Option 2
Note: This option requires the use of a flat steel plate large enough to contact the seal flange. The recommended plate dimensions are
as follows; inside diameter (1.2 -2.0 inches)
– outside diameter (3.2 inches minimum). The plate thickness must be adequate to properly
handle impact of the hammer without damaging the seal.
1. Lubricate the new o-ring with 1948791 bearing lubricate or equivalent.
2. Install new o-ring onto groove on the shaft.
3. Apply Loctite 272 or equivalent to outside diameter (OD) of press-in seal.
4. Align new press-in seal, being careful not to cut the seal on the shaft splines.
5. Utilizing the steel plate, tap on the plate with a hammer until the seal is fully seated
CAUTION: Be sure not to contact the seal with the hammer during installation. Any direct contact to the seal may result in damage to
the seal.
6. Ensure seal is fully seated by checking the gap around the flange.
7. Install new steel spacer onto the shaft and into the seal.
8. Install pulley, washer and nut. Be sure pulley is installed with same side out as before removal.
9. Hold pulley with a strap-type wrench and tighten pulley nut to 290 Nm (215 lb ft).
SEAL
STEEL PLATE
APPLY LOCTITE AROUND
SEAL OUTSIDE DIAMETER