Rocktron Patchmate Loop 8 Floor - Manual (Page 26)

26
3. Once you have pressed the Store switch from step 2, the TOP PANEL SWITCH LEDs [ 1 thru 8 ] will
blink twice and the STORE BUTTON will continue to blink signifying that the MIDI CONTROLLER
BANK information is now being displayed.
4. You may now make your MIDI CONTROLLER BANK selections based on the MIDI CONTROL-
LER BANK SETUP diagram on the following pages or you may PRESS CANCEL [ 6 ] ON then
PRESS and RELEASE the STORE BUTTON.
5. If you would like the PatchMate LOOP 8 Floor to respond to these controller changes you just made,
press and release swtich 8. When the LED is "OFF" the PatchMate LOOP 8 Floor will respond to con-
troller changes.
6. When you are ready to store the information simply PRESS and RELEASE the STORE SWITCH
(TWICE). The STORE LED will blink followed by the recall of preset 1.
Programming is now completed.
MIDI CONTROLLER PROGRAMMING (DEFAULT)
MIDI Controller Bank Setup