Rocktron Patchmate Loop 8 Floor - Manual (Page 8)

8
NOTE: The following example is to illustrate a serial chain of effects and how the
Patchmate Loop 8 Floor may be applied. It is not necessary to daisy chain each
LOOP in the order listed below. You may use any LOOP you desire and in any
order you choose.
1 LOOP Section Number "1"
These jacks are used to connect your first device in the signal chain. These jacks correspond to
the LOOP Button Number "1" on the front panel of the PatchMate LOOP 8 Floor.
2 LOOP Section Number "2"
These jacks are used to connect your second device in the signal chain. These jacks correspond
to the LOOP Button Number "2" on the front panel of the PatchMate LOOP 8 Floor.
3 LOOP Section Number "3"
These jacks are used to connect your third device in the signal chain. These jacks correspond to
the LOOP Button Number "3" on the front panel of the PatchMate LOOP 8 Floor.
4 LOOP Section Number "4"
These jacks are used to connect your fourth device in the signal chain. These jacks correspond to
the LOOP Button Number "4" on the front panel of the PatchMate LOOP 8 Floor.
5 LOOP Section Number "5"
These jacks are used to connect your fifth device in the signal chain. These jacks correspond to
the LOOP Button Number "5" on the front panel of the PatchMate LOOP 8 Floor.
6 LOOP Section Number "6"
These jacks are used to connect your sixth device in the signal chain. These jacks correspond to
the LOOP Button Number "6" on the front panel of the PatchMate LOOP 8 Floor.
7 LOOP Section Number "7"
These jacks are used to connect your seventh device in the signal chain. These jacks correspond
to the LOOP Button Number "7" on the front panel of the PatchMate LOOP 8 Floor.
8 LOOP Section Number "8"
These jacks are used to connect your eighth device in the signal chain. These jacks correspond
to the LOOP Button Number "8" on the front panel of the PatchMate LOOP 8 Floor.
PatchMate LOOP 8 Floor Back Panel