Rocktron Patchmate Loop 8 Floor - Manual (Page 29)

29
To link loops in Stereo, follow these instructions
1. Turn the PatchMate LOOP 8 Floor "ON", then press and hold the STORE button down until the
STORE LED starts "flashing". Note that this procedure must be done within 3 seconds of the PatchMate
LOOP 8 Floor being turned "ON"
2. Press SWITCH 7 (STEREO LINK), the LED above it will be lit.
3 SWITCHES 1, 2, 3 and 4 now become the STEREO LINK switches. When Switch 1 is pressed and
the LED is lit, LOOP 1 is now linked in stereo to LOOP 5 and Switch 1 now is the ON/OFF control over
the linked pair. The linked pairs are [ 1 to 5 ] [ 2 to 6 ] [ 3 to 7 ] [ 4 to 8 ].
4 PRESS and RELEASE the STORE SWITCH to execute the link.
After you have pressed the STORE SWITCH the PatchMate LOOP 8 Floor will return to the current
PRESET.
Stereo Link