Rocktron All Access - Manual (Page 41)

38
MIDI, Page 5 of 7 - Program Change Status
The fifth page of the MIDI program, Program Change Status, determines
whether or not the All Access™ will respond to incoming program changes, as well
as whether to map the incoming program changes to a preset.
If the All Access™ is set to respond to incoming program changes, it will
send out information associated with each preset just as if the buttons on the All
Access™ were pressed. (This feature is operable only when the All Access™ is
operating in BANK mode - see SETUP, Page 1).
• When set to OFF, the All Access™ will not respond to incoming
program changes.
• When set to ON, he All Access™ responds to incoming program
changes without mapping.
• When set to MAP, the All Access™ responds to incoming program
changes and maps any assigned patch changes (see MIDI, page 6).
To set the program change status:
(Œ) With the 2ND L.E.D. still lit, press the "ð" switch to access the next page
of the MIDI program, Program Change Status. (If the All Access™ is not
already in the MIDI editing mode, press "2ND", then "MIDI", followed by
"ð" four times.)
() Use the "INC" and "DEC" switches directly below the displayed Program
Change Status to select the desired status.