Rocktron Unity Tuner - Manual (Page 10)

Step 1 - plug the guitar/bass into the tuner - see “connections” section.
Step 2 - play a note on your guitar. Pluck your E string, if needed, adjust your
tuning machine on your instrument until the letter “E” appears in the NOTE
Display window.
Step 3 - if your note is flat - the “FLAT” LEDs to the left of the IN TUNE green
LEDs will light. The farther away the red LED is from the green IN TUNE LED
the more flat the tuning is. If a Flat LED is lit, tune your string up. During this
process the LEDs will begin to light and move closer to the green IN TUNE
LED.
Step 4 - if your note is sharp - the “SHARP” LEDs to the right of the IN TUNE
green LEDs will light. The farther away the red LED is from the green IN
TUNE LED the more sharp the tuning is. If a sharp LED is lit, tune your string
down. During this process the LEDs will begin to light and move closer to the
green IN TUNE LED.
Step 5 - Continue with step 3 or step 4 until the flat or sharp LEDs are not lit
and the green “IN TUNE” LED lights. At this point the string is in tune.
Step 6 - Continue steps 2-5 but using your other strings on your guitar or bass.
Tuning Instructions: