Rocktron Classic Wah - Manual (Page 10)

Specifi cations
Maximum Input
Input Impedance
Output Impedance
Wah frequency Range
Current Consumption
Power Requirements
+10dBu
1M ohm
1K ohm
400Hz (Heel Down) to 2KHz (Toe
Down)
20ma or greater
9VDC >=100ma
6
7
8
Controls and Function Descriptions - Cont.
OUTPUT Jack - using a standard guitar cable, plug this out- OUTPUT Jack OUTPUT Jack
put into the next effect in your effect chain or directly into the
input of your guitar amplifi er.
WAH ON LED - The red LED will be lit when the “wah” effect
is activated. To activate the wah - see point 2. The red LED
will not be lit when the wah is bypassed.
9-VOLT BATTERY COMPARTMENT - to access pull on
small tab labeled “OPEN”. Replace with a new 9-Volt battery.
Always remember to unplug your guitar cords from the pedal
to conserve battery life. Some battery drain may take place
when unit is plugged in (even if the unit is bypassed).
The Classic Wah (as with all Wah Wah pedals) are normally put in
the beginning of your signal chain. Although, you may place your
wah at any place in your signal chain, it usually sounds best at the
beginning - directly from your guitar (or bass).
Hints and Tips