Star Headlight & Lantern 200ADHL Dual color - Manual (Page 4)

-3-
Wiring
High/Low Power Settings (single color lights only)
There are 3 modes these lights can be set to work in:
• Constant High Power
• Constant Low Power
• Manually Switched High/Low Power
By default all single color lights are set up for Manually Switched High/Low
power. This means that you can use the Purple wire to control whether the
light operates under high power (day mode) or low power (night mode):
• High Power Only: Cut the Purple wire short and tape it off.
• Low Power Only: Connect the Purple wire to Ground.
• Manually SwitchedHigh/Low Power:
Connect the Purple wire to Ground through a switch.
CAUTION: All of our DC powered warning lights are polarity sensitive. These lights are
polarity protected only if the appropriate fuse is used. All wires connected to the
positive terminal of the battery should be fused at the battery for their rated load.
Testing the light before this fuse is properly installed will void the warranty
on the light.
Black : Ground lead - Connect to a good chassis ground.
Red : Power - Connect to the positive side of your power source (+12-24VDC)
through a switch and a 5 Amp fuse. Check your light for proper voltage.
Purple : Found only on the single color lights - Used for High/Low power selection.
• Leave disconnected for constant high power.
• Connect it to Ground for constant low power.
• Connect it to Ground through a switch for High/Low select.
Orange : Found only on dual color lights - Power for secondary color - Connect to the
positive side of your power source (+12-24VDC) through a second switch and a
5 Amp fuse. Check your light for proper voltage.\
Green : Pattern Select - Touch and release to ground to cycle through patterns.
White : Synchronization - Cut short and cap off if not synchronizing this light with
additional lights. If synchronizing, set flash patterns BEFORE
connecting white wires together.