Star Headlight & Lantern 9100LED Series - Manual (Page 2)

-1-
1. IMPORTANT: Please read all of the following instructions before installing your new
warning light.
2. CAUTION: All of our DC powered warning lights are polarity sensitive. These lights are
polarity protected only if the appropriate fuse is used. All wires connected to the positive
terminal of the battery should be fused at the battery for their rated load. Testing the
light before this fuse is properly installed will void the warranty on the light.
3. Permanent mount lights are mounted using four bolts that screw into molly well nuts in
each corner of the minibar. Mark the four mounting holes (and the center wire hole, if
you will be needing one). Mark the holes on the corners of a 14-1/2” x 5-1/2” rectangle.
If you are mounting the light on the roof of your vehicle, take extreme care to ensure that
the magnet is firmly seated on your roof, and that the pull of the magnet is sufficient to
secure the light in place. Since the composition of the metal in the roofs of different
vehicles may vary, as well as the contour, texture, and/or condition, Star cannot
guarantee the ability of the light to remain in place on a moving vehicle. It is the sole
responsibility of the owner to ensure the warning light is secure.
Care should be taken when routing the cig plug cord so that it does not
interfere with the proper operation of the driver-side or passenger-side
airbag! Failure to heed this warning may result in serious or fatal injury.
4. Check the underside of the marked locations to ensure that you do not damage any
wires or other components. Drill a 3/16”" hole in the four marked spots for the mounting
bolts, and one in the center for your wires (if applicable).
CAUTION: Take care not to drill through the headliner below.
5. If the 4 threaded molly well nuts are not already installed in the
base of your bar, install them by pressing one into each of the
four holes found on the corners of the base of the light until the
lip rests on the bottom surface of the base.
6. Route your wires through the
center hole (if applicable) and
attach the light using the four
enclosed bolts. Insert the bolts
from below, through the holes
you drilled in the mounting
surface and screw them into
the molly well nuts on the light.
Tighten until snug.
Permanent Mounting Instructions
Vacuum Magnet Mounting Instructions