Star Headlight & Lantern 9018 Series - Manual (Page 2)

-1-
1. Using the gasket as a template, mark the four
bolt holes on the mounting surface (and the
center wire hole, if you will be needing one).
2. Drill a 9/32" hole in the four marked
spots or the mounting bolts.
CAUTION: Take care not to drill
through the headliner below.
3. Insert the head of two mounting bolts
into each of the access holes found
along the slots on the bottom of the bar
and slide one to each end of the base.
IMPORTANT: Please read all of the following instructions before installing your new warning light.
Permanent Mounting
4. Route the wires through the center of the gasket and align the bolts properly BEFORE
REMOVING THE BACKING.
5. Remove the
adhesive backing
on the gasket and
carefully stick the
gasket onto the
base, over the
bolts, with the wires
routed through the
center hole.
6. Route your wires
through the
mounting surface if
applicable.
7. Install your light with the four bolts going through your mounting holes. Place a washer
and nut on each of the bolts and tighten until snug.
Slide the heads of two mounting
bolts into each bolt access hole
along each of the two
mounting slots.