Star Headlight & Lantern ULB14 StarBurst Half Phantom Undercover - Manual (Page 3)

-5-
1 Slow Warn *
2 Fast Warn
3 Superfast Warn
4 Warn Fade
5 Pre-Pop Warn
6 All Singleflash
7 Alt. Tripleflash
8 All Tripleflash
9 Alt. Quadflash w/Post Pop
10 All Quadflash w/Post Pop
11 Alt. Quintflash
12 All Quintflash
13 Alt. Pre-pop Quintflash
14 All Flicker
15 Alt. PSU Flicker
16 One Side Pop, Other Side Rapid Fire
17 One Side Rapid Fire, Other Pop
18 Comet 1
19 Comet 2
20 Delta Omega (Flash Rate Sweep)
21 Slow Warn, Superfast Warn
22 All Singleflash, All Flicker
23 Alt. Double, ALT. Quad w/Post Pop
24 All Double, ALL. Quad w/Post Pop
25 Alt Double, Alt. Pre-Pop Quad, Alt. Quad w/Post Pop, Alt Flicker
26 All Double, All Quintflash, All Quadflash w/Post Pop, All Flicker
27 All Quadflash w/Post Pop, All Doubleflash, All Flicker
28 Alt. Pre-Pop Triple, Alt. Doubleflash, Alt Flicker **
29 Alt. Pre-Pops, Alt. Flicker, Superfast Warn
30 Delta Omega, All. Double, All. Flicker
31 One Side Steady---Other side Singleflash †
32 One Side Steady---Other Side Short-Long †
33 Warn Medium (Alt. Long Singleflash) †
34 Alt. Short - Alt. Long †
35 Cycle All
† = These Patterns meet California Title 13 and SAE J595 specifications in Red and Blue versions
of the model ULB42 only. (ULB42V models DO NOT meet these specs)
* Default Pattern #1
** Default Pattern #2
 If at anytime you would like to go directly to the Slow Warn (pattern #1), simply press,
and hold the pattern select button for approximately 3 seconds. When the LEDs
flash once, release the button and the light will be in the Slow Warn pattern.
 If you would like to place the light back into the default pattern (Pattern 28: Alt. Pre-
Pop Triple, Alt. Doubleflash, Alt Flicker), simply press and hold the pattern select
button until the LED’s flash twice (approx. 6 seconds). Then release the button and
the light should be in the default pattern.
 Toggle Mode: Pressing and holding the pattern select button until the LED’s flash
three times (approx. 9 seconds) will toggle the “steady side” for patterns 31 and 32.
 Indicator LED: Pressing and holding the pattern select button until the LED’s flash
four times (approx. 12 seconds) will disable or enable the indicator LED.
 The Star Half Phantom will remember the pattern it was in when turned off and
display the same pattern when re-activated.
Warning Lights Pattern List
-2-
Please Note: Every Half Phantom™ comes with a standard baffle included.
The 274-ULB10-CH kit also includes a separate baffle that is
specifically designed to fit the 2008 Dodge Charger. It should be
used in place of the standard baffle included.
There are several optional mounting brackets that can be used to mount your Half
Phantom ™. Your light comes with the one that was selected at the time the light was
ordered. Please review the separate mounting instructions that are included, based upon
the mounting option that was selected.
274-ULB10-U1 Universal Mounting Kit
274-ULB10-CH 2006-2010 Dodge Charger
2007-2008 Dodge Magnum
2009 Dodge Ram
274-ULB10-CH11 2011-2014 Dodge Charger
274-ULB10-CP 2011-2013 Chevrolet Caprice
274-ULB10-CV 2006-2011 Ford Crown Victoria
2009 Ford F150 and F250
274-ULB10-EX 2006-2013 Ford Explorer
2007-2013 Ford Expedition
274-ULB10-IM 2008-2013 Chevrolet Impala
274-ULB10-INT 2012-2013 Ford Interceptor (Taurus)
274-ULB10-RM 2012-2013 Dodge Ram 1500
274-ULB10-TA 2007-2013 Chevy Tahoe
2007-2013 Chevy Yukon
2007-2011 Chevy Suburban
Star Headlight & Lantern Co., Inc. assumes no
responsibility for the secure mounting of this light. It is the
responsibility of the installer and/or owner to ensure the
lightbar is mounted securely. Check your light every time
you enter the vehicle to ensure that it is mounted securely.
Before installing any of the brackets,
slide the enclosed rubber channel
over the front edge of the baffle .
Mounting
Gasket Installation