Star Headlight & Lantern ULB14 StarBurst Half Phantom Undercover - Manual (Page 4)

-3-
CAUTION: Take extreme caution not to over tighten the screws!!! Over tightening
of the screws can strip the holes.
1. After the light has been mounted (see separate mounting instructions), if adjustments
permit, slide the light forward until the top of it is touching the windshield.
2. Loosen the baffle screws and carefully slide the baffle forward until the gasket is forced
slightly downward by the pressure of the windshield.
3. Tighten the Baffle Adjusting Screws to secure the baffle in place .
Baffle Adjustment
4. Once all of the brackets are securely tightened, check your mount to ensure the
desired angle is achieved. Stand in front of the vehicle and inspect the light through
the front windshield. The screws may be loosened slightly to allow for any final
adjustments necessary.
-4-
Operating Instructions
Pattern Select
The button in the left side of the light is the Pattern Select button. Each time this
switch-button is depressed, the
Star Half Phantom will cycle to the next pattern.
The Star Half Phantom is designed with thirty-five different patterns (see next
page):
Indicator LED
Located on the bottom of the Star Half Phantom is an Indicator LED. When your
light is activated, this LED will light up.
This light may be optionally de-activated if you wish. To do this, while the light is
running, hold down the Pattern Select Button for approximately 12 seconds, until the
light flashes 4 times. This will disable (or enable) the indicator LED.
The Star Half Phantom is designed for simple operation using two switches. It has a
switched cig plug for On/Off control, and a Pattern Select Button.
Pattern Select
Switched
Cig Plug
All wires connected to the positive terminal of the battery should be fused at the
battery for their rated load. Testing the light before this fuse is properly
installed will void the warranty on the light.