Star Headlight & Lantern ULB24 StarBurst Split-Phantom Undercover - Manual (Page 5)

-4-
Operating Instructions
The 3-Way Mode Switch (Flashing/Off/Steady or Pursuit/Off/Takedown)
Steady: (Takedown) mode, the LEDs will not flash, but instead will remain lit, similar
to Takedown lights.
Flashing: Pursuit mode - the LEDs will flash according to the pattern you have
selected (See Flashing (Pursuit) Mode below).
Pattern Select/Burst Mode Button
This is a momentary switch and has two different functions, depending upon which mode
the 3-Way Mode Switch is in.
3-Way Mode Switch set for Steady (Takedown) Mode:
Pattern Select/Burst Mode will “burst” your LEDs into a super-bright, high-power mode
(takedowns). This mode will activate for approximately 30 seconds then revert to the
standard steady burn mode. Please Note: Immediately after the 30 second “Burst Mode”
has ended, the light will be “locked out” of Burst Mode for 30 seconds.
3-Way Mode Switch set for Flashing (Pursuit) Mode:
Pattern Select/Burst Mode will act as the Pattern Select button. Each time this switch-
button is depressed, the Split Phantom will cycle to the next pattern. The Split
Phantom is designed with thirty-five different patterns (see next page):
Indicator LED
Located on the bottom of the right half (passenger side) of the Split Phantom ™ is an
Indicator LED. When your light is activated in any mode, this LED will light up.
CAUTION!!! Once the light is secured, route your cord such that
it does not interfere with the vision of the driver or the operation
of the steering wheel, gear shifter, and/or any airbags.
Pattern Select / Burst Mode
3-Way Mode Switch
Flashing/Off/Steady
All wires connected to the positive terminal of the battery should be fused at the
battery for their rated load. Testing the light before this fuse is properly
installed will void the warranty on the light.