Star Headlight & Lantern ULB28 Lineum Dual-Color Split-Phanto Interior LED Lightbar - Manual (Page 10)

-9-
BLACK
BARE
White w/Brown - Pursuit (Flashing White Lights) or TD Warn
Green w/Yellow - Takedowns (Steady Burn White) or TD Left
Yellow - California Title 13 Lights (Steady Red) or TD Right
Green w/Red - Pattern Select or Dim
Red - Ignition Switched +12VDC
User Supplied Switches
Orange w/Red - Level 2 Flashing Warning Lights
Orange w/Green - Level 1 Flashing Warning Lights
+12VDC
+12VDC
+12VDC
+12VDC
+12VDC
+12VDC
+ -
20 AMP
FUSE
Operating Instructions
Functions Switched Through Wires
Main control of this light is done though the wires in the harness. They should be connected
to +12VDC through several switches (user supplied) as described in the Wiring section.
Level 1 Flashing Mode (Orange w/Green)
This is usually intended as a slower,
less urgent mode typically used
when parked. The colored lights will
flash in the pattern you have them
programmed for. If Pursuit Mode or
TD Warn is activated, those lights
will continue to flash.
Level 2 Flashing Mode (Orange w/Red)
This mode is intended for high-urgency situations, such as a high speed chase, requiring
significant warning power. It is usually a faster pattern than Level 1. The colored lights
will flash in the pattern you have them programmed for. Level 2 will override Level 1
lights. If Pursuit Mode or TD Warn is activated, those lights will continue to flash.
Dim Option
DIM (Green w/Red)
f the High-Low/Pattern Option is set for High-Low (see page 5), then applying +12VDC
will dim the light (typically used in nighttime applications).
Functions Available Only with DIP switch set for Takedown Mode
Pursuit Mode (White w/Brown)
Usually activated when in pursuit of another vehicle. The white lights will flash in the
pattern you have them programmed for.
Takedowns (Green w/Yellow)
These are steady burn white lights typically used to illuminate the scene once a vehicle
has been pulled over. This mode will override all others, stopping all flashing for heads
that have Takedown mode enabled.
California Title 13 (Yellow)
When activated, the preprogrammed Red light will be activated in a steady burn mode.
Burst Mode (Green w/Yellow and Green w/Red)
Please Note: This mode is only available in Takedown Mode AND if you have the High-
Low Option disabled (see High-Low page 5 and the Dim Option section below).
This mode will temporarily “burst” the steady burn lights (typically white) into an “extra
bright” mode for 30 seconds. A 30 second cool down period is then required before the
Burst Mode can be activated again.
Functions Available Only with DIP switch set for Traffic Director Mode
TD Warn (White w/Brown)
Usually activated when a vehicle has been pulled over. The amber lights will flash in the
WARN pattern you have them programmed for.
TD Left (Green w/Yellow)
Applying +12VDC to this wire will produce a pattern directing traffic left.
TD Right (Yellow)
Applying +12VDC to this wire will produce a pattern directing traffic right.
Center-Out (Green w/Yellow) and (Yellow)
Applying +12VDC to BOTH of these wires will produce the Center-Out Pattern.